TriGorilla 3D Printer GT2560 Control Board Support Dual Extruder Power ATmega2560 for Ultimaker Ramps with USB Cable

/ 1,397 views /

fallback-no-image-34786

Specification:
Dimention: M12 x 60mm
Detection Distance: 4 mm
cable Length: 110cm
Voltage: 6-36 VDC
Type: NPN
Wiring colors:
Power (Positive): Brown
Common / Ground: Blue
Signal: Black
Package included:
1x 3D Printer LJ12A3-4-Z/BX Proximity Sensor

  • The GT2560 can not only take full place the them on respect of both software and hardware, but also features compact size, more convenient connection, and more stable
  • Adopt ATmega2560 as the main control chip, coupled with the high-performance USB serial converter FT232RQ
  • The main circuit adopts SMD fuse tube, the diode added to the power port can provide reverse protection to the whole circuit, in addition, the 5V USB is USB port protected with 500mA Recoverable fuse
  • Support 5 A4988 stepper drivers (3 for X/Y/Z axis, and 2 for extruders); the subdivision of stepper motor can be setup by dial switch, eliminating jumper caps, easier to operate
  • 3 55Amp MOSFET (with LED indicator, the actual output is restricted by the PCB board and the connector), all 3 MOSFET are equipped with heat sink to ensure sufficient heat dissipation and stable operation

Price
Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
$47.99
Visit Store
MPN 3maker-3D674
UPC 605175661348
Category