Puyu 1piece 3d Printer Control Panel Reprap Sanguinololu Ver1.3a Control Board Replacement Ramps

/ 96 views /

fallback-no-image-34868

Puyu 1piece 3d Printer Control Panel Reprap Sanguinololu Ver1.3a Control Board Replacement Ramps

Brief introduction

The circuit board design is flexible , allowing users to power availability ATX power supply power supply board , or the user can choose to install any power 7V-30V regulator kit.

The board uses a developer -friendly expansion port that supports I2C, SPI, UART, and ADC pin. All 14 expansion pins can be used as GPIO. Note : The Sanguinololu design is excellent, but if you want to run a hot bed insufficient to carry traces of current required to operate the heat bed Sanguinololu board.

Feature

1 supports multiple communication configuration – two thermistor circuit connector – 2 N-MOSFET extruder / bed, or any – selectable 12V ( or supply voltage ) / 5V voltage stopper – edge connector make a right angle connector – 13 extra pin can be used to expand and develop – 6 analog and 8 digital , with more features also support SD.

2 supports multiple power configuration – ATX power logic and motor supplies ( hard disk needs MOLEX connector, and a 4pin ATX connector optional extra 12v/supply voltage ) – provided by the USB bus logic , optional on-board voltage regulator (MOLEX HDD connection can not be installed at the same time ) – screw Terminal 7-35V5mm of

3 small board design – as 100mm x 50毫米(4 “× 2”)

4.Sanguino clone , Atmel ‘s ATMEGA644P – ATMEGA1284 backward compatible !

5.UART1 (RX and TX)

6.I2C (SDA and SCL)

7.SPI (MOSI, MISO, SCK)

8.PWM pin ( 1 )

9.Analog I / O (5)

  • supports multiple communication configuration – two thermistor circuit connector – 2 N-MOSFET extruder / bed, or any – selectable 12V ( or supply voltage ) / 5V voltage stopper – edge connector make a right angle connector – 13 extra pin can be used to expand and develop – 6 analog and 8 digital , with more features also support SD.
  • supports multiple power configuration – ATX power logic and motor supplies ( hard disk needs MOLEX connector, and a 4pin ATX connector optional extra 12v/supply voltage ) – provided by the USB bus logic , optional on-board voltage regulator (MOLEX HDD connection can not be installed at the same time ) – screw Terminal 7-35V5mm of

Price
Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
$79.99
Visit Store
UPC 567721165895
Category