Jambo 3.00mm Transparent ABS 3D Printer Filament - 1kg Spool (2.2 lbs) - Dimensional Accuracy +/- 0.05mm - 150M

/ 1 views /

no-image-4743

Jambo 3D Printer Filament

1KG (2.20 lbs) Spool
3.00mm Filament Diameter (Dimensional Accuracy +/- 0.05mm, roundness)
ABS (Acrylonitrile Butadiene Styrene) 3D Printer Filament
Recommended Extrusion/Nozzle Temperature 220°C – 250°C
Spool Length: about 150M
11 colors to choose: black, white, red, green,yellow, blue, orange, gray, purple, gold, transparent
Compatible with the following 3D printers (with heated beds): Reprap, Afinia, MakerBot, PrintrBot, UltiMaker, Airwolf, Makergear, Up!, Lulzbot, Flashforge, Solidoodle, 3doodler (pen), Delta, Mbot, Type A

1) Filament not extruding properly?
A: Check the type of filament you’re working with and set the proper extruder temperature based on the filament type and heated build platform if applicable; trial and error. Rule of thumb is to set the extruder temperature to the highest temperature for the specific filament, then decrease the temperature by 5¡ãC until properly extruded. Please note this will vary with each 3D printer.

2) How do I store my filament?
A: Most filaments tend to absorb moisture from the air; because of this your filament can become brittle and slowly degrade the quality. It’s recommended to keep unused filament and store it in a storage container or zip lock bag with a desiccant.

3) Won’t the print stick to the build platform?
A: First, review FAQ #1. Second, for PLA it’s recommended to use blue painters tape and ABS it’s recommended to use kapton tape. If printing with ABS and the print will still not stick to the build platform you can use “*ABS Sludge” a little goes a long way. You can use this on the build platform on top of kapton tape.

  • 1 KG ( 2.20 lbs) Spool;approximately 150Meters
  • 3.00mm Filament Diameter (Dimensional Accuracy +/- 0.05mm)
  • Printing temperature range is 220 – 250°C
  • ABS (Acrylonitrile Butadiene Styrene) 3D Printer Filament
  • Compatible with the following 3D printers (with heated beds): Reprap, Afinia, MakerBot, PrintrBot, UltiMaker, Airwolf, Makergear, Up!, Lulzbot, Flashforge, Solidoodle, 3doodler (pen), Delta, Mbot, Type A

Price
Category
Keywords