Asiawill® MKS Gen V1.2 3D Printer Control Board with USB cable / 5 DRV8825 Drivers for Arduino

/ 74 views /

fallback-no-image-34947

1, 2560 and ramps1.4 collection on a board, solved the problems of ramps1.4 complex combination interfaces and failures.

2, Can replace the motor driver, support 4988 drivers and 8825 drivers.

3, Circuit board USES the high quality 4 layer board, and the thermal optimization; Ramps is 2 layer board.

4, Using high quality MOSFET tube, the effect of heat dispelling is better.

5, Using special power supply chip, support the 12V and 24V power input, solve the problem of Ramps voltage conversion chip heat.

6, Can accept 24V input, under the same system power can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating.

7, You can use open source firmware Marlin, configuration and ramps1.4 are exactly the same, can be directly replace ramps1.4.

8, can be directly connected Ramps1.4, 2004 LCD control panel and the LCD panel (12864).

9, Reserved motor pulse and direction of output port, convenient external large current to external large current (e.g., 2A, 5A) motor drive circuit.

10, Retain Ramps1.4 Servos, AUX 1, AUX – 2 interface, provide 3 x 5V output, 3 x 12V output interface.

Quantity: 1Set

Material: FR4

Packing List:

1 x MKS Gen V1.2 controller board

1 x USB cable (50cm)

5 x DRV8825 drivers

  • MKS Gen V1.2 3D Printer Control Board
  • with USB cable / 5 DRV8825 Drivers for Arduino
  • 2560 and ramps1.4 collection on a board, solved the problems of ramps1.4 complex combination interfaces and failures
  • Can replace the motor driver, support 4988 drivers and 8825 drivers

Price
Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
$65.64
Visit Store
MPN 1195
UPC 701979716618
Category