Anycubic DRV8825 Stepper Motor Driver with Control Expansion Shield Board for Reprap 3D Printer

/ 327 views /

fallback-no-image-34781

Special reminder: ※Note installation direction, otherwise it may even drive the motherboard burned.

Product introduction:

※You can use the A4988/DRV8825, insert the attention direction, otherwise it will burn the drive.

※ Jumper hit ON DP indicating the position of 16 segments (4988) or 32 segments (8825).

※ Jm is connected with the motor.

※ Jv connection 5V and 12V-24V power supply.

※ Jc E\S\D\G are respectively connected with the Enable\Step\Dir\Gnd driving signal output.

Package List:
1*Drv8825 Driver
1*Expansion Shield Board

  • Note installation direction, otherwise it may even drive the motherboard burned
  • DRV8825 stepper motor driver and expansion shield board
  • DRV8825 Driver:Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
  • 4-layer, 2 oz copper PCB for improved heat dissipation
  • Adjustable current control support you to set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates

Price
Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
$8.99
Visit Store
MPN AC-SKIT-150
Category