Anycubic 3D Printer Controller RAMPS 1.4 Mega Shield for Arduino Reprap Prusa Mendel

/ 233 views /

fallback-no-image-9061

Specification:

Heater / fan output and three thermistors MOSFET circuits;

Fusion 5A additional safety and component protection;

Extra bed heating control fuse 11A;

Suitable for 5 Pololu stepper driver board;

Pololu board pin socket, easy to be replaced and removed;

I2C and SPI pin for extended use; All MOSFET into PWM pins for versatility;

Rated current: 3A; LED indicates when the heater output;

Option 2 motors connected to the Z Prusa Mendel

Package Size: 12.2cm x 6.8cm x 3.2cm

Package Weight:72g


Package Includes:

1 x 3D Printer Controller for RAMPS 1.4

  • Fully assembled & tested, no soldering required
  • It is designed to fit the entire electronics needed for a RepRap in one small package for low The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion
  • A number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack
  • It has Cartesian robots and requirements of the extruder

Price
Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
$9.69
Visit Store
MPN AC-D0004-B
UPC 726630042394
Category