3D Printer Control Board Combo Set - Upgrade Version

/ 82 views /

fallback-no-image-34792

The A4988 micro-stepping motor driver is a Pololu format compatible driver, ideal for Shield and breadboard compatibility. The A4988 at 2 amps capable and 35 volts of drive capacity makes this a perfect match for 3D printer all-in-one boards, such as “RAMPS” with plug and play compatibility.The micro stepper driver supports 5 step modes for bipolar stepper motors. The A4988 driver also supports automatic current decay, reducing motor noise, heat, and power consumption while increasing step accuracy.
Features:
Low RDS (ON) output
Optional heatsink included
Automatic current decay mode detection / selection
Mixed with slow current decay modes
Synchronous rectification for low power dissipation
Internal UVLO
Crossover-current protection
3.3 and 5 V compatible logic supply
Thermal shutdown circuitry
Ground fault protection
Load short-circuit protection
Five selectable step modes: full, 1/2, 1/4, 1/8 and 1/16
Specs:
Drive voltage: 5~35v
Logic voltage: 3.3~5v
Format: 16pin (Pololu format)
Drive amps: 2A
*Note: This is not an original Arduino product

  • Micro-controller: ATmega 2560
  • Operating Voltage: 5v
  • Input Voltage: 7~12v recommended
  • Input Voltage: 6~20v max limits
  • Digital I/O Pins: 54 (of which 15 provide PWM output)

Price
Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
$81.99
Visit Store
MPN HC-HK-661000059-0
UPC 720132264551
Category