300x300mm 12V Silicone Rubber Heater for 3D Printer Heated Beds



You are looking at the ultimate heating element for your 3D printer’s bed. This is a premium silicone rubber heater, normally used in industrial environments to heat large tanks of liquid. We had these custom made to be the fastest, most evenly heated elements available. They include a built in 100k thermistor for accurate readings with easy setup. They run off 12v power so no dangerous voltage and they CAN be run directly with virtually all 3D printer electronics. These heaters are flexible and WILL REQUIRE a flat build surface such as glass to mount to.

  • 300mm x 300mm / 12″x12″
  • Durable Silicone Rubber Construction
  • Extremely Even Distribution of Heat
  • Industrial Duty Cycles For Long Life
  • Heats To 120 Degrees C in About ONE Minute (assuming adequate power supply)
  • Integrated 100k Thermistor For Accurate and Reliable Temperature Readings
  • Integrated Thermistor Beta Value 3950K
  • Thermistor Leads Are Insulated and Ready To Go
  • Most Even Heating Even to the Edges of All Heater Types
  • Includes Integrated 100K Thermistor (Epcos #1 Table)
  • FLEXIBLE and Requires Build Surface (Basalt, Aluminum, Glass etc.)
  • Adhere with Silicone to Build Surface

Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
Visit Store
MPN QSR-300X300-12-2