BIQU Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer(Pack of 2pcs)



Dimensions: 60*50mm
Net Weight: 25g
Max Current: 25A(Enhance heat dissipation)
Helps 3D printer equipped with the controller board (capable of max 15A) become more powerful
With this add-on module to board lead the maximum current up to 25A
If you intend to use heated bed with your 3D printer that uses a 12V power supply, then this module is recommended, else it may cause excessive current during times which may burn the connectors on the controller board, According to the thermal power of the bed, please choose the appropriate power supply, with sufficient margin. If it is large power heated, we suggest 24V power supply, under the same power requirements, current is less than 12 v

Package Included:
2*Heat bed Power Module

Please double-confirm the wire you connect is right, if there have any issue please contact us before leave negative review and feedback, thanks!

  • Currently work with the Anet A8
  • Completely solve the hot bed power is too large and the load current issue
  • General add-on heated bed power expansion module
  • With this addon module to your 3D printer motherboard you can lead the maximum current up to 25A
  • Under the premise of normal cooling, it work stable under I(Max)=25A, the current must not exceed 25A while the process working

Visit Store
UPC 611801199673